810018 Customs, rear fender support ''Bobber''. Steel

Getting a bobber fender to sit just right often requires some custom fabrication, and this Westland Customs rear fender support kit makes the job much easier. The kit is sold as a kit and includes two supports approximately 35cm long, 25mm wide, and 3mm thick. It also comes with a bottom mount weld-on M8 threaded bracket and all necessary zinc-plated mounting hardware. The supports come with a pre-drilled hole at the top for fender mounting, while the lower section is left undrilled so you can shorten it to your specific required height. Supplied in raw steel, these supports are ready for you to paint or powder coat once your mock-up is complete.